Some of the Telecom connections
are now starting to do a CHAP negotiation instead of PAP only. Our default
config’s offer to only do PAP, but the new connections come back asking to do
CHAP (despite it not being offered in PPP ... go figure, so much for
negotiation). So to make it work we have to tell the router to refuse the CHAP
request, and then it falls back to PAP again.
Add something like this:
Interface Dialer0
ppp chap refuse
From: nznog-bounces@list.waikato.ac.nz
[mailto:nznog-bounces@list.waikato.ac.nz] On Behalf Of Terry Wilson
Sent: Friday, 23 April 2010 12:30 p.m.
To: NZNOG@list.waikato.ac.nz
Subject: [nznog] Xtra BBA Issue with Cisco 877
Afternoon,
I’m struggling with an issue that I’m hoping someone might
be able to shed some light on for us. New connection in Queenstown (new
phone + data) with ADSL enabled on line. Had some issues initially with
the connection going down while the IP address was assigned, Telecom have
resolved this and the 2Wire modem now reports that it is up and
connected. Trying to connect a Cisco 877 into the same line, we get
ATM to come up (CD light is on) but PPP will not come up; talking user through
it but everything looks ok.
I have had the router sent back down here and it tests fine
on our existing Telecom ADSL test connection, back on site and it still won’t
get an IP or authenticate. T3G coverage is pretty rubbish so I can’t remote
control from here; may need to find a competent tech in Queenstown to go over
and have a look for us.
Any suggestions would be appreciated; been working on this
with Telecom for four days now and as far as they are concerned it’s a Cisco
issue.
Thanks,
Terry
This
e-mail message has been scanned for Viruses and Content and cleared by MailMarshal