For the HSPA+7 cards, use a different dialler string: chat-script gsm "" "AT!SCACT=1,1" TIMEOUT 60 "OK" Also, you need to carefully check the GSM profile settings on the card, in exec mode: show cellular 0/0/0 gsm ... There's a very useful doc at http://www.computecnetworks.com/?q=node/51 which is a life-saver. Contact me off-list if you need help. Kerry On 12/02/2014 15:37, Laurence Bullivant wrote:
Afternoon,
This is a reach out for anyone else using Cisco881g / Cisco887vag routers with 3G backup.
We have just started getting the new routers into stock that use the new cellular modems. Our normal connection scripts don't work any more and we have been unable to find the required connection details for either vodafone or telecom connections.
I am hoping in exchange for BEER, someone out there has worked it out. (We have a pending case with TAC but I hope this will be faster).
Currently we are using:
----------------------------------------------------- chat-script gsm "" "ATDT*99#" TIMEOUT 30 CONNECT ! controller Cellular 0 ! interface Cellular0 ip address negotiated ip nat outside ip virtual-reassembly in ip virtual-reassembly out encapsulation slip dialer in-band dialer string gsm dialer-group 1 async mode interactive ! interface Vlan1 ip address 10.0.0.1 255.255.255.0 ip nat inside ip virtual-reassembly ! ip nat inside source list 1 interface Cellular0 overload ip route 0.0.0.0 0.0.0.0 Cellular0 ! access-list 1 permit any dialer-list 1 protocol ip permit ! line 3 exec-timeout 0 0 script dialer gsm modem InOut no exec transport preferred none transport output none -----------------------------------------------------
The issue is that the dial script always times out. Hopefully this is all recognizable to someone who has gone though the same pain as we are.
Thanks in advance.
-Laurence
laurence(a)bullivant.co.nz
_______________________________________________ NZNOG mailing list NZNOG(a)list.waikato.ac.nz http://list.waikato.ac.nz/mailman/listinfo/nznog