Hello there, We currently peer to 2 providers. We have several SubNets of I.P's from them. Currently the Ethernet0 Interface of our Cisco Router handles all the I.P. Addresses. I was wondering if somebody here could advise me on how to create separate Sub-Interfaces for theses like we have with the Serial Interfaces. Our Ethernet Interface looks slightly like this at the moment: interface Ethernet0 description CISCO ROUTER ip address x.x.x.x x.x.x.x ip address x.x.x.x x.x.x.x secondary ip address x.x.x.x x.x.x.x secondary no ip directed-broadcast I wish to split these up into 3 Sub-Interfaces. That way, it'll make it far easier to Graph Bandwith etc. Regards, Sahil Gupta NET4U Limited ------------------------------------ NET4U -- www.net4u.co.nz Home of the new - $24.95 128k ADSL Nationwide Internet Service Provider ------------------------------------ - To unsubscribe from nznog, send email to majordomo(a)list.waikato.ac.nz where the body of your message reads: unsubscribe nznog