Quick question from a routing noob:

I've just acquired 210.48.96.88/30. The two IP addresses in the block are intended for a couple of vmware instances.
We're not using anything nice like a Cisco router, just a Linksys stand-in for now. It has some basic static routing capabilities.

I had a short conversation with Iconz support but I'm not feeling very confident about the result. I've been instructed (or rather I said "this is what we came up with" and I got a vague "yes") to add the following entry to the routing table (where 202.37.231.84 is the existing IP that we're using as an external address):

Destination: 210.48.96.88
Subnet: 255.255.255.252
Gateway: 202.37.231.84
Interface: Local

It's the gateway bit we're unsure of - won't this cause a loop? My mate is concerned that it's not going to work as it needs to be on the same subnet.

Cheers
Justin