From memory (and only Josh can truely answer this.) The main difference between R2 and all the country varients is how CLI is handled.
The orig MFC R2 spec was a bit ambigous on how it did this so all the countries did it differently. Ascend had a HUGE job getting the Chinese R2 to work properly. So R2 will come up but it might not handle CLID the right way. New Zealand should get it right. Dean (Who does not speak for Ascend because he no longer works there) On Tue, Aug 14, 2001 at 01:30:10PM +1200, John Lynch wrote:
Thouse settings look good, butt crank up the answer delay to around 400, I seem to remember that some customers modems would not connect if the max answered too quickly.
As for software versions, I've been through just about all of them, finishing off with 9.0.0 which resulted in reboots, and call center timeouts, we then swiched to PRI lines and all our dail in woes were gone. You may like to try explicitly setting the Sig Mode to R2 as well, I've tried both seemed to have made no difference either way.
Sig Mode=NEW ZEALAND Switch Type=CAS Framing Mode=G.703 etc etc etc
Thanks Craig Whitmore Orcon Internet http://www.orcon.net.nz
--------- To unsubscribe from nznog, send email to majordomo(a)list.waikato.ac.nz where the body of your message reads: unsubscribe nznog
John Lynch System Administrator (string and tape specialist) Wise Net
--------- To unsubscribe from nznog, send email to majordomo(a)list.waikato.ac.nz where the body of your message reads: unsubscribe nznog
--------- To unsubscribe from nznog, send email to majordomo(a)list.waikato.ac.nz where the body of your message reads: unsubscribe nznog