I looked into that too, however as I can't ascertain the chipset the DV120 is based on, I'm loathe to put it anywhere near the 'fussy' Infineon DSLAMs Orcon use. Currently I operate a Netcomm NB6 in half-bridge, but as you say, no IPv6 Support.
Cam
-----Original Message-----
From: Jean-Francois Pirus [mailto:jfpn@clearfield.com]
Sent: Thursday, 17 March 2011 4:31 p.m.
To: Cameron Bradley
Cc: nznog
Subject: Re: [nznog] IPv6 needed on ADSL
The main problem at the moment is a lack of a CPE that properly supports IPv6, my attempts to build custom firmware for BCM63xx modems has been largely thwarted for now by Dynalink/Netcomm's failure to provide proper board definitions in their GPL released source code (it boots, but doesn't identify the board properly) If anyone wants to donate their old ADSL2+ (preferably Broadcom based, working or bricked) modems to the cause, please email me offlist. The resulting firmwares will be made available to all.
I also stopped waiting for a CPE that works, and I wanted something easily/locally available, so I went instead for a TP-Link TL-WR1043ND running OpenWrt as the router and a Draytek Vigor 120 as a modem (it does PPPoA to PPPoE "transaltion")
Works like a charm IPv6 and all.
PS: I first tried a TD-8840 in half-bridge mode, but that doesn't do IPv6.
--
------------------------------------------------------------------------
Jean-Francois Pirus <jfp@clearfield.com> Technical Manager
Phone (+64-9) 358 2081 Clearfield Software Ltd
Fax (+64-9) 358 2083 1st Floor 8-10 Whitaker Place
Mob (+64-21) 640 779 P O Box 3901 Auckland, New Zealand
------------------------------------------------------------------------
_______________________________________________
NZNOG mailing list
NZNOG@list.waikato.ac.nz
http://list.waikato.ac.nz/mailman/listinfo/nznog