Cheers, I thought the same about the tx and rx gain but the option is there? On 6/12/06, Philip D'Ath wrote:

If it is a Cisco router, you want:

isdn switch-type basic-net3

interface BRI0/0/0

no ip address

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice voice (if your using it for voice)

And if being used for voice:

voice-port 0/0/0

compand-type a-law

cptone NZ

Point to multipopint, but you can happily define a static tei. I sometimes use a static tei of 10. TE,. TX and RX gain don't make much sense, since it is a digital circuit.

------------------------------

*From:* Sam Banks [mailto:dodgywhitemaori(a)gmail.com] *Sent:* Monday, 12 June 2006 8:17 a.m.

*To:* nznog(a)list.waikato.ac.nz *Subject:* Re: [nznog] Telecom BRI

Thanks

On 6/10/06, *Matt Mariu* wrote:

Definitly Point to multipoint.

-----Original Message----- *From:* Sam Banks [mailto:dodgywhitemaori(a)gmail.com] *Sent:* Wednesday, 7 June 2006 10:30 *To:* nznog(a)list.waikato.ac.nz *Subject:* [nznog] Telecom BRI

Hi Guys

Does anyone know the default settings for Telecom BRI ISDN lines. Point to multipoint or Point to point? TE or NT? TX and RX gain?

Thanks

Sam

-- A good friend will help you move, a really good friend will help you move a body.

-- A good friend will help you move, a really good friend will help you move a body.

-- A good friend will help you move, a really good friend will help you move a body.