Hi All, I’ve been quite happily running a Cisco router at home on Snap/2degrees, but with the upgrade to UFB its not coping with the throughput. I’ve managed to locate a suitably equipped ASA, however I cant get IPv6 going. The config I have on the ASA is very similar to that of the router: nterface GigabitEthernet0/7 description 2degrees nameif EXTERNAL security-level 0 no ip address ciscoasa# sh run int gi0/7.10 ! interface GigabitEthernet0/7.10 description 2degrees vlan 10 nameif 2degrees10 security-level 0 pppoe client vpdn group 2degrees ip address pppoe setroute ipv6 address autoconfig ipv6 address dhcp ipv6 enable ipv6 dhcp client pd 2degrees-v6 However, if I remember correctly the IPv6 dhcp assignment happens inside the PPPoE connection once its established. Can anyone confirm that or provide a working config? In case someone wants versions, the ASA is on 9.9.2 (asa992-smp-k8.bin) Thanks, Bill Sent from Mail for Windows 10